AR-DV10 update support instructions

AR_DV10_UpdateSupport.exe is a special utility to assist the firmware update procedure when there was a problem during firmware update, and the receiver's menu and buttons do not repond anymore.
Before going ahead with the procedure, be sure to backup your receiver's memory data and settings on SD card! See manual page 53 for instructions.

Required hardware:
-AR-DV10 in its charging cradle
-SD card
-A windows computer (Win 7, 8, 10)
-Mini-USB cable (not supplied)

Required files:
-Receiver firmware file
-AR_DV10_UpdateSupport.exe
-USB driver AR-DV10 driver.inf (only needed if Windows cannot install the generic driver through Windows update)

Proceed as follows:
-Copy the receiver firmware to the SD card, and insert the SD card into the receiver.
-AR-DV10 should be inserted in the charging cradle, to avoid power loss.
-Connect the receiver to the PC with a mini USB cable
-Power on the receiver (Windows will install the USB driver if this is the first connection)
-Execute AR_DV10_UpdateSupport.exe
-Go though steps 1 to 4.
Done